Advertisement
D223TD | Installation Instructions |
Figure 2: Inside the D223TD
1 -
Data wire connector (J1)
2 -
Wire opening
2.0
Installation
1. Select a mounting location.
Do not place the D222TD Keypad in areas
of extreme cold such as uninsulated
buildings, refrigerated areas, outdoors, or
areas where the temperature can drop below
0°C (+32°F).
Do not mount the D222TD in locations
exposed to direct sunlight. Direct sunlight
makes the display less visible and can
damage the keypad's components.
Mount the D223TD on a flat wall, or on the
following Bosch Security Systems accessories:
•
D54B Brass Flush Mount Kit
•
D54C Chrome Flush Mount Kit
•
D55 Command Center Desk Stand
•
D56 Command Center Conduit Box
2. Route the wire to the keypad location.
See the control panel's Installation Guide for
information about the maximum length of keypad
cables and wire resistance. Route data wire away
from electrical, telephone, and other data wiring.
Bosch Security Systems | 12/03 | 74-07491-000-B
2.0 Installation
1
1
2
3
4
5
6
7
8
9
0
CLEAR
2
ON
3 -
Display adjustment potentiometer (R50)
4 -
S1 DIP switch
3. Splice the connectors to the wires.
Connect the three-wire cable to the control panel.
Use solder to splice the connectors to the wires.
Insulate all exposed splices with tape so
they do not short to one another.
4. Remove the front cover from the enclosure base.
Using a small flat-bladed screwdriver, gently push
back the two bottom cover tabs. As you push back
the tabs, lift the bottom of the cover away from the
base and remove the cover.
5. Connect the keypad.
Plug the data wire into the serial data wiring
connector ( J1) in the keypad (see Figure 2).
6. Mount the enclosure base.
While pushing excess keypad wire back into the
wall or gang box, place the enclosure base on the
wall in the desired location. Use a center punch or a
pencil to mark the locations of the mounting holes.
Mount the enclosure base to a recessed single-gang
wall box. Secure the enclosure base to the wall or
the gang box.
A
B
C
*
3
4
EN | 3
Advertisement
